for Release Version 1.097
This commit is contained in:
@@ -28,8 +28,8 @@
|
||||
//#define UBITX_DISPLAY_LCD1602I //I2C type 16 x 02 LCD
|
||||
//#define UBITX_DISPLAY_LCD1602I_DUAL //I2C type 16 x02 LCD Dual
|
||||
//#define UBITX_DISPLAY_LCD2004P //24 x 04 LCD (Parallel)
|
||||
//#define UBITX_DISPLAY_LCD2004I //I2C type 24 x 04 LCD
|
||||
#define UBITX_DISPLAY_NEXTION //NEXTION LCD
|
||||
#define UBITX_DISPLAY_LCD2004I //I2C type 24 x 04 LCD
|
||||
//#define UBITX_DISPLAY_NEXTION //NEXTION LCD
|
||||
|
||||
//#define UBITX_DISPLAY_NEXTION_SAFE //Only EEProm Write 770~775
|
||||
#define I2C_LCD_MASTER_ADDRESS_DEFAULT 0x27 //0x27 //DEFAULT, if Set I2C Address by uBITX Manager, read from EEProm
|
||||
@@ -187,7 +187,7 @@ extern byte I2C_LCD_SECOND_ADDRESS; //only using Dual LCD Mode
|
||||
* ground and six pins. Each of these six pins can be individually programmed
|
||||
* either as an analog input, a digital input or a digital output.
|
||||
* The pins are assigned as follows (left to right, display facing you):
|
||||
* Pin 1 (Violet), A7, SPARE
|
||||
* Pin 1 (Violet), A7, SPARE => Analog S-Meter
|
||||
* Pin 2 (Blue), A6, KEYER (DATA)
|
||||
* Pin 3 (Green), +5v
|
||||
* Pin 4 (Yellow), Gnd
|
||||
@@ -217,7 +217,7 @@ extern byte I2C_LCD_SECOND_ADDRESS; //only using Dual LCD Mode
|
||||
* The second set of 16 pins on the Raduino's bottom connector are have the three clock outputs and the digital lines to control the rig.
|
||||
* This assignment is as follows :
|
||||
* Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
|
||||
* GND +5V CLK0 GND GND CLK1 GND GND CLK2 GND D2 D3 D4 D5 D6 D7
|
||||
* GND +5V CLK2 GND GND CLK1 GND GND CLK0 GND D2 D3 D4 D5 D6 D7
|
||||
* These too are flexible with what you may do with them, for the Raduino, we use them to :
|
||||
* - TX_RX line : Switches between Transmit and Receive after sensing the PTT or the morse keyer
|
||||
* - CW_KEY line : turns on the carrier for CW
|
||||
|
Reference in New Issue
Block a user